PRODUCT INFORMATION

Application Instructions

A secure fit starts with careful preparation and a compatible surface.

WATCH STANDARD INSTALLATION
Installation instructions video
KONSILEE / INSTALL

A simple, secure installation

Follow these steps to install your Konsilee products

1

Prepare

Clean with isopropyl alcohol, then let the surface dry completely.

2

Position

Remove the plastic backing film. Apply product, ensuring to press from one corner to the other, pushing out any air bubbles.

3

Press & wait

Press firmly. Leave the product empty and dry for at least 12 hours before use to allow adhesive to bond. 

KORA CORNER CADDY

Installing your Kora

The Kora has specific corner requirements. Follow these checks after the standard product instructions above.

01 Check the Corner

Install on a square, 90° corner. If you are testing the Kora on a curved corner, do so by holding the kora up to the corner prior to removing the plastic protective films. Both sides should effortlessly sit flush against both walls simultaneously.

02 Align Both Sides

Position yourself so that you are below the caddy, and ensure the bottom of the caddy is straight and level.

Tip: Use a horizontal grout line as a guide to ensure your caddy is level. Position the bottom of the caddy at least 5mm above the grout line.

03 Bridge One Grout Line

Remove one side's backing film whilst the opposite side is against the wall, slightly out from the corner. Slide the product straight along the surface, towards the corner softly. Stop once the product first touches the wall.

4 Check Alignment & Apply

Check the bottom of the caddy has been applied level and straight, then remove the film from the opposite side, firmly pressing this side against the wall.

5 Press and wait

Press firmly. Leave the product empty and dry for at least 12 hours before use.
WATCH KORA INSTALLATION
KONSILEE / KORA VIDEO

General Installation Notes: 
Do not apply water to the contact surface prior to product application, as this will not allow the product to properly attach. The adhesive should not pass over any grout lines.Do not overload the product. All bottles or items placed in the pouches should fit comfortably, keeping the silicone relaxed and unstretched. Products should not pull, bulge or distort the pouch or silicone.Konsilee products are not suitable to store breakable items, such as glass. Razors should be stored with their protective cover on at all times. Products should be regularly cleaned to ensure cleanliness is maintained. You can find our cleaning guide here Product Cleaning & Care